9
8
CONSTRUCTION & TECHNICAL DATA
USER MANUAL
BATTERY
Always fully charge the battery before using it for the first time. The battery will warm up while
charging, this is normal. Remember the battery is an consumable part that is subject to natural wear.
When it is worn out, replace it with a new one. The battery has overload safety systems that protect
the device and will work if the device is overloaded and overheated. You should then wait about
30 minutes for the device and the battery to cool down. However, in some cases, the battery may
be permanently damaged. In such cases, the battery should be replaced with a new one. In the event
of damage related to overload, the battery is not subject to complaint. Charge the battery regularly,
at least once every 3 months. Even if the device is not in use. Discontinue use of the device if the
battery is discharged and the device stops while operating. Do not turn it on again, just replace
or recharge the battery immediately. An attempt to operate with a discharged battery may lead
to permanent damage to the battery.
1. Tube for the silicone cartridge
2. Extruding plunger
3. Piston rack
4. Piston handle
5. Piston release button
6. Speed control knob
7. Main switch
8. LED lamp
Voltage
DC 18 V
Speed of extrusion of silicone
0,5-8 mm/s
Piston pressure
2500 N
Weight
2,3 kg
Additional equipment (only in OK-03.4313)
Battery
2 Ah
Charger
21 V / 2,5 Ah
Charging time
1 h
Summary of Contents for OK-03.4312
