5
Assembly: Level the Insert Ring
1. If the removable Insert Ring is not installed in the
center of the Pro Lift plate, press it firmly into the
opening to snap it in.
2. Use your finger or a flat piece of wood to determine
whether the Insert Ring is flush with the plate. If it
is not perfectly flush, you will need to adjust it to
avoid material from catching when routing.
Fig. 1.
3. To make the adjustments, press the Snap-Lock button
to remove the aluminum Insert Ring from the plate.
4. Set the Pro Lift upside down on a smooth surface and
loosen the nuts securing the leveling set screws.
5. Use the included M2 hex wrench to adjust the set
screws as needed.
6. Snap the Insert Ring back into the opening and check
to see whether it’s flush with the plate.
7. If it’s not, repeat Steps 3-6 until it is. Then tighten the
locking nuts on the set screws.
Fig. 2.
The Insert Ring included with the Pro Lift
has a 1
1
⁄
2
" bit opening. Additional Insert Rings with other bit
opening sizes are sold separately.
Fig. 1
Fig. 2
Leveling
Set Screw
Locking Nut
