5
Fig. 4 - Arm and Top Assembly
Fig. 3 - Vertical
Support Assembly
6. Press the Rubber Bumpers (9) into the appropriate holes
on the angled faces of the Vertical Supports (20).
Fig. 3.
7. Slide the Table Extension (23) into the Frame Assembly (22),
depressing the bullet pins in the Table Extension (23) to
allow it to fully insert.
Fig. 4.
8. Attach the Left and Right Flip Stops (24 and 25) at the
appropriate locations on the Table Extension (23) with 4-Star
Knobs (10) and 3/8" Washers (15). The small tabs at the
bottom of the Flip Stops should be oriented toward the
outside edge of the assembly.
Fig. 4.
9. Attach the Latch Arm (26) to the back of the Frame
Assembly (22) with 1/4" x 2" Bolts (11), 1/4" Washers (2)
and 1/4" Lock Nuts (1).
Fig. 4.
10. Set the Frame Assembly (22) on the Vertical Supports (20),
aligning the holes in the downward tabs of the frame with
the holes at the top of the supports. Attach with Shoulder
Bolts (12), 1/2" Washers (13; these go on the outside of the
tabs) and 3/8" Lock Nuts (14).
Fig. 4.
6
8
9
7
4
4
21
4
7
9
20
20
6
8
4
6
6
4
4
6
6
4
22
24
23
10
12
13
13
14
14
13
13
12
10
25
Tab should point to
the outside edge of
the assembly
Bullet Pin
Bullet Pin
15
26
2
1
11
15
9
9
