SECTION 4 — PROGRAMMING
SSC-500 Hydraulic Press Solid-State Control
Rockford Systems, LLC
30
Call: 1-800-922-7533
(Continued on next page.)
PSDI TMR sec
XX
ENTER
Selects the Program Menu
Item
PSDI TMR sec
ENTER
XXX =
Current
PSDI
timer value
Press the DOWN and UP
Program the
PSDI
time and return to Main Menu
MAIN
MENU
arrows to decrease or
increase the current timer
Figure 4.11
PSDI TIMER Programming Flowchart
Setting Type:
Time - seconds
Range:
02 - 30 sec
Factory Setting:
02 sec
Optional Programming Overview
(requires options module)
PSDI TIMER sec
Select the
PROG
position on the Program/Run selector switch.
Press the
t
and
s
buttons on the keypad to scroll through the
program options. Press
ENTER
when the LCD displays
PDSI TMR sec.
The display now reads:
XX
Where
XX
= a number between 02 and 30 sec.
Press the
t
and
s
buttons on the keypad to increase or decrease
the
PSDI
timer. Pressing and holding the arrow keys will change the
numbers at a rapid rate. Press
ENTER
to program the
PSDI
timer to
the displayed time and return to the main menu level. The LCD again
displays
PDSI TMR sec
.
Function
The PSDI timer starts timing once the stroke is complete and the ram
is at the TOS limit switch. If the timer expires before the next break
occurs, the PSDI mode will deactivate. To reactivate the PSDI mode of
operation, depress the PSDI prior action push button.
ASINGLE MODE (A
utomatic
S
ingle
S
troke
)
Select the
PROG
position on the Program/Run selector switch.
Press the
t
and
s
buttons on the keypad to scroll through the
program options. Press
ENTER
when the LCD displays
ASINGLE MODE
.
The display now reads one of the following:
AUTO/SINGLE OFF
AUTO/SINGLE ON
Press the
t
and
s
buttons on the keypad to change the mode options.
Press
ENTER
to turn on or turn off
ASINGLE MODE
and return to the
main menu level. The LCD again displays
ASINGLE MODE
.
Function
The
ASINGLE
or Automatic Single Stroke Mode of operation is used
when a continuous stroke operation is desired but the press is faster
than the material feeding equipment. When this mode is ON, each press
cycle can be initiated by the material or material feeding equipment.
This mode requires a prior action station* and the
ASINGLE
timer
for the
ASINGLE
input. See ASINGLE TMR programming description.
Refer to the wiring diagram sheet 2 for information on wiring the
ASINGLE
inputs.
*Contact factory for this station if it was not supplied
ASINGLE MODE
OFF
ENTER
Selects the Program Menu
Item
ASINGLE MODE
ENTER
Current
ASINGLE MODE
either
OFF
or
ON
.
Press the DOWN and UP
arrows to turn Automatic
Single Stroke Mode ON
or OFF
Program the
ASINGLE MODE
and return to Main Menu
MAIN
MENU
Figure 4.12
ASINGLE MODE Programming Flowchart
Setting Type:
Lift Selection
Range:
Off/On
Factory Setting:
OFF
