Rockford Fosgate RFX9220, Installation & Operation Manual

Page: 21 / 76

21
Tuner has poor
reception Antenna is disconnected or not
properly grounded to vehicle Check connections and installation of antenna
and repair or replace as necessary
T
ROUBLESHOOTING
S
YMPTOM
D
IAGNOSIS
R
EMEDY
Antenna cable is intermittent or
damaged Disconnect antenna and test with known
working antenna. If tuner works, check
installation and repair antenna as necessary
Antenna is wrong type for
AM/FM frequencies Consult your local Authorized Rockford
Fosgate Dealer for proper antenna selection
Disc will not load
into Source Unit
(also see error
codes)
Voltage applied to Red and
Yellow wires is not between
10.8 and 16 volts or there is no
voltage present Check battery, connections and fuses, and
repair or replace as necessary. If voltage is
above +16 volts, have the electrical system
inspected by an authorized car service center
Disc will not eject
(also see error
codes) Voltage applied to Yellow wire is
not between 10.8 and 16 volts
or there is no voltage present Check battery, connections and fuses, and
repair or replace as necessary. If voltage is
above +16 volts, have the electrical system
inspected by an authorized car service center
ERROR 1
(Initialize Error) No initialization Press the reset button
Mechanism is jammed and
loading motor (or driving circuit)
is defective Repair the mechanism and
loading motor (or driving circuit)
ERROR 3
(Loading Error) Foreign objects are preventing
the disc from loading Check CDP mechanism load area by
removing faceplate and repair as necessary
Loading area in mechanism and
loading motor (or driving circuit)
is defective Repair the mechanism and loading motor
(or driving circuit)
ERROR 4
(Eject Error)
Foreign objects are preventing
disc from ejecting Check CDP mechanism eject area by
removing faceplate and repair as necessary
Eject area in mechanism and
ejecting motor (or driving circuit)
is defective
Repair the mechanism and loading motor (or
driving circuit)
ERROR 6
(Transverse Error) Transverse motor or switch is
defective or Traverse area of disc
is damaged Check CD mechanism motor and switch.
Put in a different disc!
ERROR 7
(Servo Error) Excessive dirt or dust on disc Clean disc to remove dirt or dust as necessary
Disc is warped, cracked,
damaged or severely scratched Put in a different disc!
ERROR 9
(TOC Error) Disc is cracked, warped or
severely damaged Put in a different disc!
Laser pickup is defective Have service center repair laser pickup
Servo unit in CDP mechanism is
not operating properly Check the servo circuit area and repair as
necessary