8
Step 8 - Attach the Dash Kit to the Center Pocket
On the rear of the pocket, you will need to remove one of the
circular knockout panels providing an access hole to route wiring
from your source to your vehicle.
Step 9 - Attach the Dash Kit to the Center Pocket
To attach the dash kit to the center pocket, insert the wiring into
the pocket first. You will need to connect your wiring to the source
unit and feed the wiring out the rear of the pocket hole that was cut.
Next place the dash kit onto the front of the pocket. Insert the tab
on top of the dash kit into the slot on the pocket.
Once the dash kit is locked in, you will need to use the two screws
to attach the bottom of the dash kit to the pocket.
NOTE: Make sure the speed clips are lined up correctly or the
screw will not be able to be tightened.
Step 10 - Reinstalling the Dash Kit
Slide the dash kit, source unit and wiring back into the dash.
Retattach the rear support bracket to the pocket.
Once the the rear brace is secure the dash kit is installed and now
the vehicle can be put back together
Installation
