12. Assemble cut end of MUDFLAP into FLAP CLAMP by either sliding
or pushing it down onto top of MUDFLAP with the square holes
on the smooth side.
Note:
Figure 10.
Repeat for 2nd MUDFLAP.
9
SUPPORT ROD with the NYLON INSERT HEX NUTS facing your
vehicle.
as desired for your vehicle. Line up small hole in FLAP CLAMP
depending on vehicle size.
• Inner Hole - for small and mid-sized vehicles
• Center Hole - for full-size vehicles
• Outer Hole - for large vehicles, such as dually trucks and
small motor homes
Finally
, insert the small M5 FLAP RE
TAINER BOLT through
HEX NUT.
Figures 1 & 6.
Repeat for 2nd MUDFLAP.
14. Assemble TRIM PLATE
S. Insert M6 TRIM PL
ATE SPACERS into
TAMERS TRIM PLATE with the eigh
t M6 TRIM PL
ATE BOLTS
(Locking STAR PIN
TM
[STAR PIN
TM
wr
ench included]), M6 FL
AT
WASHER
S, and M6 NY
LON INSERT HEX NUTS as shown in
Figure 10.
(20 in-lbs torque [10 mm socket or wr
ench]).
Repeat for 2nd MUDFLAP.
Note:
Figure 10
15
. The ARMS of the
HUB ASSEMBLY may
be loosened and
The FLAP SUPPORT
RODS must also
be rotated slightly so
the MUDFLAPS hang
Figure 11.
10
Figure 11
