Figure 3
Figure 4
Figure 2
1. Slide HUB ASSEMBLY
onto BALL MOUNT
and insert into vehicle
RECEIVER HITCH.
See Figures 2 & 3.
Assembly Instructions
Account for all parts listed in the Parts List.
2. Secure the BALL
MOUNT with HITCH
PIN. Adjust HUB
ASSEMBLY to desired
3. Tighten the two M10
BALL MOUNT CLAMP
BOLTS to hold
CENTER HUB in place.
(F
or assembly only)
See Figure 3.
4. Loosen or Remove
all thr
ee M6 ARM
CLAMP BOLTS from
each HUB ARM.
Carefully insert
the two FLAP
SUPPORT RODS
thru HUB ARMS.
Place ROD END
CAP over the end
of rods, hex side
facing away from
vehicle, insert
END CAP BOLT
thru END CAP
BOLT HOLE,
with M5 NY
LON
INSERT HEX NUT.
See Figure 4.
5
5
. Re-inst
all M6 ARM CLAMP BO
LT
S and M6 NY
LON INSERT HEX NUTS
back in
(Do not
adjustment holes face forward horizontally.
Figure 5.
7. Slide FLAP CLAMPS over the FLAP SUPPORT RODS with square
holes facing away from vehicle. Do not secure with FLAP RETAINER
BOLTS yet.
(See
Figure 6
Figure 6.
6
Figure 5
Figure 6
