26
Upper Post Disassembly
2 0 0 ( A 2 ) & 4 0 0 ( B 1 ) H o u r S e r v i c e
U p p e r P o s t D i s a s s e m b l y
Clamp the upper post head into the vise with flat soft jaws.
NOTICE
Clamp only the flat surfaces of the post head. Do not clamp over the
bleed port or on the hose barb port.
Remove and discard the top cap assembly.
Insert a 1.5 mm hex wrench into one of the cross holes in the IFP tube.
Carefully pull the IFP tube up. Use your other hand to guide the IFP
tube straight out of the upper post using care not to scratch the inside
of the upper post with the hex wrench.
Wipe the outer surface of the IFP tube and set it aside on a clean shop
towel.
NOTICE
Do not scratch the inner surface of the upper post, or the IFP tube.
Surface scratches can cause leaks and reduce performance.
If the IFP tube is scratched, it must be replaced.
1
2
1.5 mm
