The Eliminator
™
Rotogauge Replacement
For LP Gas & NH
3
Service
P6293 Series
Materials of Construction*
Head, Gears, Gear Housing, Cross Stud, Bearings
& Float
Stainless steel.
Centershaft, Float Rod, & Support Tube
Stainless steel.
Drive Magnet
Alnico.
Gasket
Spiral wound, teflon filled, stainless steel.
Adapter
Cold-rolled steel.
Counterweight
Stainless steel.
Note:
For threaded gauge installation instructions see MS-516.
When or der ing, specify:
1.
Model number.
2.
Tank I.D.
WARNING:
Carefully ensure that gauge and adapter are
ad e quate ly pro tect ed from dam age that might cause leak age
of tank contents.
* Materials and specifications are subject to change with out notice.
Pressure ratings sub ject to change due to tem per a ture and other en vi ron men tal considerations.
Adapter 0022-05276
1" NPT
75°
75°
15°
15°
Support Tube
As Required ±
1
⁄
8
"
Float Rod
As Required ±
1
⁄
8
"
The Measure of Excellence
11616 Harry Hines Blvd.
•
P.O. Box 29242
•
Dallas, TX 75229
•
(972) 241-2161 •
FAX
(972) 620-3374
Website
http://www.rochestergauges.com
•
05/17/13
WARNING:
Determine and in stall the appropriate replacement gauge based on system re quire ments. The gasket type
supplied may not be suitable for all applications and for those applications other gas ket materials may be available. The in -
for ma tion contained here in is in tend ed for guideline use only and the suitability of any part for a particular ap pli ca tion must
be de ter mined by the user prior to installation. Improper gauge or gas ket selection or application may re sult in seal failure
and sub se quent release of tank contents.
WARNING:
Even if gauge registers empty, tank may contain high pressure and flammable gas. Do not remove gauge or other
pressure containing fittings unless precautions against release of tank contents have been taken. A hazard of fire or explosion
may exist if proper methods are not used when removing or installing the gauge or gasket. Replace gasket if gauge is removed.
Do not reuse gasket. When reinstalling gauge head align head for proper orientation of the float inside tank. Torque head or
mounting screws evenly in several steps based on mounting screw size, gasket material & gauge head size & style.
CAUTION:
Improper gauge selection or application may result in in ac cu rate gauge readings. Release of tank
contents as well as damage to equipment and safety hazard may result if tank is overfilled. Fuel exhaustion may
occur if tank contents are less than indicated. This gauge is not a substitute for a fixed liquid level gauge or weight
measurement device that may be required for filling.
WARNING:
IMPROPER APPLICATION, INSTALLATION, OR USE OF THIS GAUGE MAY CAUSE SERIOUS INJURY OR
PROPERTY DAMAGE.
