Roche CoaguChek XS Pro, Operator'S Manual

Page: 82 / 156

5
• Testing a Blood Sample
82
5.3 Performing a test
1 Check the battery level.
2 Check that the date and time are correct. Correct
any wrong entries as described in Chapter 4, Meter
Setup/“Setting the date”.
If a lockout ( Operator or QC Lockout ) is displayed instead
of the Patient Test button, you must run a liquid quality
control test before you can perform a patient test (refer to
Chapter 6, Control Testing and Quality Control ). When the
meter is in lockout status, a test cannot be performed.
The next steps depend on whether you work with or
without patient lists.
If the Patient Test button is available, but a lockout is
displayed, a test can only be performed as a STAT test (if
this function is enabled and if there are still STAT tests
available).
For more details on STAT test configuration see pages 71
and 94.
■
If the battery icon turns red (one bar left), there may
not be enough power left for another test.
■
If there are no bars left in the battery icon, you cannot
perform any more tests. Power the meter off using the
button.
In both cases, restore power by inserting new batter-
ies, recharging the battery pack, or using the power
adapter.
Main Menu 09:15 am
04/19/2012
Control Test
Review Results
Setup
Patient Test
Main Menu 09:15 am
04/19/2012
Control Test
Review Results
Setup
QC Lockout
Logout
Main Menu 09:15 am
04/19/2012
Control Test
Review Results
Setup
Patient Test
Logout
QC!