INSTRUCTION MANUAL
ASSEMBLY, INSTALLATION, USE AND MAINTENANCE.
Rev. 11/2012
Rocam Losi s.r.l. declines every responsibility on any print and/or transcription mistake contained in this booklet
Rocam Losi s.r.l. can change features and datas of this booklet with the proposal of keeping on increase the quality of its products.
Anytime and without notice
, this booklet can’t be considered as contract with third parties.
3
4. Installation
This item is packed and shipped assembled. The manufacturer
declines every responsibility of damage of someone or something caused by
the failure to comply with the instructions of this manual.
Do not make any structural change to the trolley.
The elements composing the trolley (plastic, polyurethane foam, bubble
wrap, Styrofoam, cardboard, etc.) must be kept away from children as potential sources of
danger and must be collected and disposed off separately in accordance with local
regulations.
The manufacturer declines every responsibility of damage of someone or something
caused by the failure to comply with the instructions of this manual.
After the unpacking process, proceed by removing the adhesive plastic tape before
starting up the unit. Any residual glue has to be removed carefully (do not use abrasive
cleaners).
The device is designed to run on AC to the voltage specified on the technical data
plate (located on the bottom of the tank).
The grounding line is marked by the colours yellow/green and must not be
interrupted.
The device is provided with a cable in accordance with the CE regulations and with
has CE and schuko plug (that can be replaced, when necessary, with a different plug,
suitable for the specified wattage and in accordance to the current regulations and
guidelines; when necessary, replace the provided cable with a new one with the same
features).
Before starting up the appliance:
• Check if the electrical system can withstand the appliance’s load (WATT as indicated
on the technical plate);
• Make sure that the electrical system is provided with ground connection according to
the current norms and guidelines;
• Connect the appliance to the ground network of the system through a cable to be
connected to the corresponding screw placed on the outer casing of the unit itself.
First use of the appliance:
The first use of the appliance may give off unpleasant smells and
smoke within the heated cabinet, this is due to the fat residues.
FOR THE FIRST USE IT IS RECOMMENDED TO TURN ON THE
UNIT EMPTY AND WITH DOORS OPENED FOR FEW MINUTES,
in this
way you will avoid the residues to affect the food contained by the unit
