Robur OCDS006, Installation And Operation Manual

Page: 9 / 16

Installation and operation manual – remote control
9
Figure 7.1
Operating status OFF
▶
heating only: only operation in heating mode is enabled for
the production of hot water to the internal modules.
In this mode the boiler will produce hot water at the set
temperature, modulating the heat output as the set-
point temperature approaches.
8 CLOCK AND TEMPERATURE SETTING
The setting of the clock and of the temperature setpoints of
the remote control and of the boiler is done by pressing the
key several times according to the menu shown in Table
8.1 p. 9.
Table 8.1 Identification icon of the selected state
Selected status Identification icon
clock
day temperature
night temperature
The value of the item is displayed in the lower-left corner,
instead of the time, together with the flashing of its iden-
tification icon. To end the setting operation, press the
key repeatedly until all the identification icons are
off.
8.1 CLOCK SETTING
1. Press the
key: the time flashes (Figure 8.1
p. 9).
Figure 8.1 Hour setting
2. Turn the knob to set the desired value.
3. Press the knob to confirm the value entered. The
hour stops flashing and the minutes start flashing (Figure
8.2
p. 9).
Figure 8.2
Minutes setting
4. Turn the knob to set the desired value.
5. Press the knob to confirm the value entered. The min-
utes stop flashing and the day of the week starts flashing
(Figure 8.3
p. 9).
Figure 8.3
Day setting