Robur OCDS006, Installation And Operation Manual

Page: 14 / 16

14
15 ERROR CODES
For information about the error codes that may appear
on the remote control display during operation, refer
to the Installation, use and maintenance manual of the
specific Caldaria appliance used.
16 RESTORE DEFAULT VALUES
You can reset the settings of the remote control to their factory
settings.
The default values of the temperatures are:
▶
Day temperature: 20 °C
▶
Night temperature: 16 °C
▶
Manual temperature: 20 °C
The factory-set weekly heating program is shown in Table
16.1 p. 14.
Table 16.1
Weekly heating program
Days of the week Night Day
Monday - Friday
00.00 ÷ 06.00
08.00 ÷ 16.30
22.00 ÷ 00.00
06.00 ÷ 08.00
16.30 ÷ 22.00
Saturday - Sunday
00.00 ÷ 07.00
23.00 ÷ 00.00
07.00 ÷ 23.00
How to reset default values
1. Set the remote control to the OFF mode.
2. Press and hold down the
and keys for longer
than 5 s.
3. The operation success will be confirmed by the word dEF on
the display (Figure 13.2 p. 13).
Figure 16.1
Restore default values
17 COMPLETE RESET
Faults or other technical reasons may require a total reset of the
remote control.
How to perform a complete reset
1. Using a screwdriver, slide the remote control interface out of
the rear fixing box, applying slight pressure on the two lower
tabs (Figure 17.1
p. 14).
2. Press button 1 (Figure 17.2 p. 15).
3. After a complete reset, the time and day of the week must be
set again (Paragraph 8.1 p. 9).
Figure 17.1
Complete reset