6
3.
To install the servos in the chassis sides, continue threading each of the four 6-32 flat
head cap screws, up through the servo flange holes, into four 6-32 nuts as shown.
Make sure you have all of the bolts threaded into the nuts before tightening them
down, othewise, it’ll be hard to thread them all in. Also, make sure the servo wire is
pointing toward the bottom of the Botster™, and that the servo mounting flange is
flush with the bottom of the chassis side.
Here’s what the chassis sides should look like when this step is completed.
©2004-2005 Summerour Robotics Corporation – Botster™ Assembly Manual Version 1.4 – 05/15/2005.
Botster™ and Botster Brand™ are Trademarks of Summerour Robotics Corporation 2004-2005.
