16
16.
(Optional)
If you ordered a Generic or CMUcam2 turret, note the position of the adjustable
turret servo horn on the tilt servo, remove it, and modify it as shown using a
razor blade or xacto knife. This will provide clearance with the rear vertical
deck when the Botster is fully assembled. Make sure you cut the horn as shown
below with the serrated side down. You’ll only need to trim the one side
shown.
Now bolt the servo horn back onto the servo in the same position from which
you removed it.
17.
Bolt the Generic or CMUcam2 turret onto the top of the middle deck as shown
with the previously threaded in 6-32 x 1/2” flat head cap screws.
©2004-2005 Summerour Robotics Corporation – Botster™ Assembly Manual Version 1.4 – 05/15/2005.
Botster™ and Botster Brand™ are Trademarks of Summerour Robotics Corporation 2004-2005.
