• CONTROL PANEL
R 2 Dice / R 2 Ultra Dice
Red knob
=
Off
switch
Green knob
=
On
switch
Black knob
=
Pulse
control
ASSEMBLY
• BOWL ATTACHMENT
1) With the motor base
facing you, place the
bowl onto the motor
base with the handle
toward the front. Turn
the bowl just off-center
and to the left as you
lower it onto the base.
2) Then, turn it back to
the right, (counterclock-
wise) locking it onto the
motor base tabs.
6
INTRODUCTION TO YOUR NEW
R 2 Dice • R 2 Ultra Dice
The R 2 Dice / R 2 Ultra Dice is a versatile machine
designed to meet your professional needs. It can
perform a number of tasks, as well as save much in
time and labor.
This food processor consists of a bowl assembly and
a vegetable preparation attachment. The 3 quart
bowl is used for chopping, grinding, pureeing,
blending, mixing, and kneading ingredients used in
most recipes.
A wide range of cutting plates are available for use
with the vegetable preparation attachment. Cutting
plates are available for slicing, waved slicing,
grating, pulping, julienne and dicing.
Its numerous functions will open the door to a whole
new culinary world.
Thanks to its simple design, all components
requiring frequent handling for maintenance or
cleaning can be easily assembled or removed.
All users should read this operation manual before
operating the machine.
SWITCHING ON
THE MACHINE
• ADVICE ON ELECTRICAL CONNECTIONS
Before plugging in, check that your power supply
corresponds to that indicated on the machine’s
serial number plate.
3) Place the blade onto
the motor shaft. Rotate
the blade until it drops
into place. The bottom
blade should be level
with and just off the
bottom of the bowl.
4) Note the plastic tab
on the bowl lid. Place
the lid on the bowl with
the tab turned to the
front and slightly to the
left of the bowl handle;
then, turn the lid back to
the right until it comes to
a stop with the tab over
the bowl handle.
The device is now ready for use.
• VEGETABLE PREPARATION ATTACHMENT
The vegetable preparation attachment consists of
two main detachable parts: the continuous feed
attachment and the continuous feed lead.
1) With the motor base
facing you, fit the conti-
nuous feed attachment
onto the motor base; the
exit chute should be at
the rear of the machine.
W A R N I N G
This appliance must be plugged into a
grounded socket (risk of electrocution).
