Robot Coupe MP 350 Combi Ultra, Manual

Page: 14 / 21

13
27/11/2020
Make sure the plug is pushed in far enough (two
stages). If it is not, the control buttons will not work.
After the cord has been
connected to the handle and
plugged into the mains, a
green indicator light indicates
the presence of electrical
current in the cord, the correct
connection of the cord to the
appliance and the correct
operation of the cable.
• FOOT SEAL
In order to maintain a perfect watertight seal
between the foot and the bell it is necessary to
check the wear of the seal regularly and replace it if
necessary.
• WASHER
The washer can be greased using a suitable food
safe lubricant.
In order to maintain a perfect watertightness it is
necessary to check the wear of the washer, and if
necessary, to replace it.
• CARTRIDGE
You need to change the cartridge :
- If liquid starts seeping into the foot
- If there is any play in the blade
1) Cartridge dismantling :
Position the knife dismantling tool C on the cartridge
B . Remove the cartridge from its place by knocking
D on the knife dismantling tool C with a plastic
mallet.
W A R N I N G
From time to time, check:
- The state of the 3 buttons’ watertight
membranes. Even the tiniest cracks will allow
liquid to seep in.
- The state of the blender housing. This, should
not show any signs of cracking or any
abnormal openings which could allow access
to the live components.
2) Cartridge mounting :
Direct the ears of cartridge
B
in order to be aligned
with the groove of the bell
A
. Push the cartridge with
the hand in the direction
of arrow, then clip on into
the bell thanks to the knife
dismantling tool.
v
olTage
indicaTor
lighT
1 st
s
tage
2 nd
s
tage
Procedure for replacing the power cord:
1) Use the dismantling tool supplied with the new
replacement cord.
2) Press the push button (see photo) and pull on the
cord without releasing the dismantling tool.
3) Installing the new cord:
Connect the Easy-Plug to the motor housing.
Before doing so, make sure the electrical plug is not
connected to the power supply.
Connect the electrical plug to the power supply.
1
2