Device Admin
RoboSHOOT
+
©
User Manual
Page 49
Reset to
Factory Defaults (All unit types)
: At power
up hold
Side plus Full Top
buttons until LEDs
complete cycling one-by-one. If successful, the main
LEDs will indicate Yellow with rapid Red flashing.
Wait 5 seconds and continue use or turn off unit.
Profile Select Enable (MX-15
+
only)
:
Continue to hold Side plus Full Top buttons after
Reset to Defaults until main LEDs flash Green three
times in succession. This disables profile
selection/editing capability. This function is
unavailable on the MX-20 as its button functions are
set via App Settings.
Change Radio Channel
: At power up hold
Side
button until LEDs complete cycling one-by-one. If
successful, the Main Yellow will flash three times
rapidly, then the Green Group LEDs will flash three
times indicating the new channel number coded per
the same table used for version number indication
on
p50. There is normally no need to change the
channel even in the presence of other units.
However, you choose to, for the MX-20
+
it is best to
change channels via the App to keep the channel
values in sync.
