tm2627 Jan-20
15
You can find more information at
Shutting Down
When shutting down for periods of less than 24 hours, you may leave any
remaining flossugar in the spinning head.
Turn off power to the heating element switch (12) and capture the remaining
cotton candy as the head cools down. When the coil cools to the point that
“snow” is produced, then cover the head with the “No Snow” tool and allow the
head spin for 5-7 minutes to fully cool down before turning off the main power
switch (11).
Onc
e cool to the touch, wipe out the inside of the “No Snow” tool, and put it
back over the spinning head for protection. You can also cover this with a paper
or plastic bag to protect the flossugar from dust, debris and insects.
The machine and Floss Pan should be wiped down with a damn cloth to remove
excess flossugar as needed.
If you are shutting down for longer than one day, then you should perform a
complete cleaning of the spinning head as described in the Technical
Maintenance section below.
Do not leave unused flossugar in the spinning head for more than a day or two
as it can harden/caramelize and effect the balance of the head during future
sessions, which could ultimately result in failure of the machine.
During transportation always secure the chassis using the transportation lock-
down nuts. This will prevent possible damage of the machine and prolong its
life.
