Servo Installation
Use a small Phillips screwdriver to remove the center
screw on all three servos, as well as the circular servo
arm.
Attach the servo to the body as shown in Figures 10 & 11
with four Servo Screws (20). Be sure to secure all four
screws. Pay attention to the orientation of the servos.
Figure 9
Figure 10
Figure 11
Figure 12
Attach a second servo to the other side of Roach in the
same fashion, as seen in Figure 12.
Figure 13
After attaching the two servos, your Roach should like
Figure 13.
