12
2.7 REV
This function reverses the direction of operation of
the servos related to transmitter steering, throttle,
and channel 3 operation.
1. Press "ENTER" to see FUNCTION MENU.
2. Press "+" or "-" to choose REVERSE, and press
"ENTER" to enter REVERSE adjusting interface.
3. Press "ENTER" to choose each Channel.
4. Press "+" to increase and "-" to choose
"REV" or "NOR" .
5. Press "EXIT" to save your setting and leave REVERSE interface, and back to the
function menu interface.
Note: However, when the position set by trim or sub trim shifts from the center, the
center becomes the opposite side.
TERMS: ST-STEERING, TH-THROTTLE, AUX-AUXILLIARY
2.8 ST_CURV
This function is used to change the sensitivity of the steering servo around the neutral
position. It has no effect on the maximum servo travel.
Note: When the setting is not determined, or the characteristics of the model
are unknown, start with 0% (when EXP is set to 0%, servo movement is linear)
1. Press "ENTER" to see FUNCTION MENU
2. Use the +/- Keys to select the ST CURV function and press ENTER.
3. Use the +/- Key to change the value.
4. Press EXIT to save and return to FUNCTION MENU, press EXIT again to return to
the Main Screen.
•
STEERING CURVE adjusting value range: -100% ~ +100%
•
Default is 0% (Linear)
Steering EXP adjustment
When you want to quicken steering operation, use the "+" button to adjust the + side.
When you want to make steering operation milder, use the "-" button to adjust the -
side.
When ending setting, return to the function menu by pressing the "EXIT" button.
TERMS: M-MODE, R-RATE
2.9 TH_CURV
This function makes the throttle high side and brake side direction servo operation
quicker or milder. It has no effect on the servo maximum operation amount. For the
Summary of Contents for R01502
Page 8: ...8 2 2 Menu introduction ...
Page 9: ...9 ...
