11
•
Connecting the motor:
The #A, #B, #C wires of the ESC can be connected with the motor wires freely (without any sequence). If the
motor runs in the opposite direction, please swap any two wire connections.
•
Connecting the receiver:
Plug the gas channel cable on the controller into the TH / Gas channel on the receiver. The gas channel cable
outputs the voltage of 6V to the receiver and the steering servo. Be careful not to connect a separate battery to
the receiver, otherwise your ESC may be damaged.
•
Connecting the battery:
Proper polarity is extremely important. Please make sure that the plus (+) is connected to plus (+) and minus (-)
is connected to negative (-) of the battery. Reversing the polarity on your regulator from the battery will damage
your regulator, which is NOT covered by the warranty!
Throttle Range Setting (Throttle Range Calibration)
In order to make the ESC match the throttle range, you must calibrate it when you begin to use a new ESC, or a new
transmitter, or change the settings of neutral position of the throttle stick, ATV or EPA parameters, etc.
The following pictures show how to set the throttle range with a FutabaTM transmitter.
1. Switch off the ESC, turn on the transmitter, set the direction of throttle channel to ”REV”, set the “EPA/ATV”
value of throttle channel to “100%”, and disable the ABS function of your transmitter.
2. Hold the “SET” key and then switch on the ESC, and release the “SET” key as soon as possible when the red
LED begins to flash.
Note: If you don’t release the “SET” key as soon as the red LED begins to flash, the ESC will enter the program
mode, in such a case, please switch off the ESC and re-calibrate the throttle range again from step A to step
D.
3. Set the 3 points according to the steps
shown in the pictures on the right side.
1) The neutral point
Move the throttle stick at the neutral
point, and then click the SET key, the
green LED flashes 1 time.
2) The end point of forward direction
Move the throttle stick at the end point of
forward direction, and then click the SET
key, the green LED flashes 2 times.
3) The end point of backward direction
Move the throttle stick at the end point of
backward direction, and then click the
SET key, the green LED flashes 3 times..
4.
Throttle range is calibrated; motor can be
started after 3 seconds
