10ft Wide Polytunnel Assembly Instructions
Copyright © Robinson Polytunnels 2009 - 2018
14
8
Take up the slack in the polythene by rolling the drive tube into the
polythene. Slot the gearbox assembly onto the square shaft and slide
the guide tube into tube on the gearbox bracket.
9
Hold the guide tube onto the inside faces of the base rail and side rail
and fix it to the base rail with an M8 x 50 coach screw.
10
With the gearbox handle, wind the
curtain up to the side rail. Fix the top
end of the guide tube to the side rail
with an M8 x 50 coach screw. Fit a
PVC plug into the top end of the
guide tube.
11
Check that the curtain rolls up parallel to the base rail and side rail and adjust the PVC clips if necessary.
12
Cut a notch out of the base rail where the gearbox touches to allow the
drive tube to rest directly on top of the base rail.
Summary of Contents for 10ft Wide Polytunnel
Page 1: ......
