9
Cleaning and Maintenance
Clean the Lint filter:
Please unplug the power cord prior to any cleaning. The lint filter
must be in place whenever drying. It must be cleaned before each
use.
Removing the filters: Remove by pulling outwards with fingers,
inserted into the four holes around the exhaust vent shroud.
The filter is in 3 parts: Exhaust vent shroud, lint filter and
exhaust filter (as shown in figure1)
Cleaning the filter: Separate "exhaust vent shroud", "lint filter''
and "exhaust filler''. Clean the lint on the lint filler and exhaust
filter with a soft brush or vacuum cleaner. Do not damage the
filters (as shown in figure 2)
Re-installing the filter: After cleaning, assemble in the sequence of
"exhaust filler - lint filler- exhaust vent shroud", align the recesses
in the center with the projection in the center of the drum. Make sure that it is firmly inserted (as shown in figure
3).
Clean the air intake filter:
The filter should be cleaned once a month.
Remove by pulling outwards holding the upper and lower ends of the air intake shroud. Remove the filler inside the
shroud and clean it with a soft brush. Reassemble and install as before.
General cleaning of interior and exterior of the dryer:
Do not wash directly with water.
Do not use thinner, gasolene or alcohol.
Do not use any type of spray cleaner when cleaning the interior. If dryer drum becomes stained, clean the drum
with a damp cloth. Remove any residue before drying the
next load. Clean cabinet with mild soap and water.
Do not use harsh or abrasive cleaners, this could damage the
dryer.
