6
Installation -
continued
2.
Fix two rear screws
C
on the underside of the cabinetry in the positions indicated (pg 4 Installation position -
Mounting to underside of cabinetry).
3.
Lift and slide rangehood into place so that the screws are in the correct position relative to the key-ways.
Ensure upwards pressure is applied to the front of the rangehood to prevent the weight of the rangehood
being taken solely by the rear screws, and fix the two front screws in place
D
.
4.
Tighten two rear screws
C
.
Recirculation mode
1.
This unit comes from the factory in recirculation mode. There is a recirculation grille fitted to the top of the
unit that will allow the cleansed air to return to the kitchen.
Please note, should the unit be installed under cabinetry, consideration should be given to allowing a short
length of duct to vent the re-circulated air to the top of the cabinets.
2.
Replace aluminium filters with charcoal filters (see pg 7 for part numbers).
Notes:
o
Please remember to fill out the details on the warranty certificate (do not post).
o
Remove any plastic coating from the product.
D
C
Note: Side of rangehood removed for greater visibility
