4
Installation
Installation Procedure
Cooktop must be placed absolutely horizontal.
•
Suitably protect the edges of the cut aperture.
•
Connect the cooktop to the mains power supply (see instructions for the connection of the cooktop to the
mains power supply).
•
Fix the 4 brackets to the sides.
•
Insert the cooktop into the cut aperture.
•
Press the cooktop firmly towards the worktop from above.
Connection to the Power Supply
Connections must be carried out by a qualified electrician only. The earth protection must comply with the national
regulations.
1.
Use the cable already attached to the appliance for connection to the power source.
2.
Prior to any attempted connection check that the voltage indicated on the rating plate is in line with your
home power supply.
•
The rating plate is located underneath the appliance.
•
The appliance is manufactured for use with the power supply voltage 220-240 V~.
3.
The electric wiring should be equipped with a circuit breaker able to isolate the appliance from the mains in
all points, with the distance between terminals of at least 3 mm in open position. This may be done by
means of fuses, safety switches, etc.
4.
The connection should be selected in accordance with the declared charge capacity of the mains and the
fuse power.
5.
Such appliances are allowed to be mounted on one side next to a high kitchen cabinet, the height of which
may exceed that of the appliance. On the opposite side however, only a kitchen cabinet of equal height as
the appliance is allowed.
6.
Upon the completion of installation, live wires and isolated cables must be adequately protected against
accidental touching.
7.
In accordance with the mains voltage, the appliance should be connected in line with the attached diagram.
8.
The earth wire (PE) must be connected to the terminal marked with the earth symbol.
9.
Connection may be carried out by means of:
•
Rubber coated connection cables, model H05RR-F with yellow-green earth cable;
•
Rubber coated connection cables, model H07RN-F with yellow-green earth cable.
10.
The power cable must lead through the relief safety device, protecting it from accidental pull out.
11.
Upon the completion of installation switch all the hotplates on for about 3 minutes to check the proper
functioning
Attention:
Only qualified electricians should attempt any repairs on the appliance; always disconnect the power
supply beforehand.
Installing the foam gasket
Before inserting the appliance into the opening in the kitchen benchtop, the supplied foam gasket must be attached
to the lower side of the glass ceramic (glass) cooktop between the benchtop and cooktop.
Do not install the appliance without the foam gasket.
The gasket should be attached to the appliance in the following way:
•
Remove the protective film from the gasket.
•
Then, attach the gasket to the lower side of the glass, approximately 2-3mm from the
edge.
•
The gasket must be attached along the entire length of the glass edge and should not
overlap at the corners.
•
When installing the gasket, make sure that the glass does not come into contact with any sharp objects.
