Robin America EH72, Service Manual

Page: 42 / 74

– 38 –
20) IGNITION COIL
Temporally fit ignition coil to crankcase.
Adjust air gap between ignition coil and flywheel
using a thickness gauge and tighten bolts.
THICKNESS GAUGE IGNITION COIL
WIRE
STOP
DIODE
Fig. 5-46
COOLING FAN
M5 BOLT and
WASHER : 4 pcs.
Fig. 5-47
GOVERNOR
LEVER
GOVERNOR SHAFT
ROD SPRING
GOVERNOR ROD THROTTLE LEVER
Fig. 5-48
Connect wiring from stop diode to the primary
terminal of ignition coil.
21) COOLING FAN
Attach cooling fan onto flywheel.
22) CARBURETOR
Set gasket onto intake manifold and install
carburetor.
Tightening Torque
16.7 - 18.6 N ・ m
(170 - 190 kgf ・ cm)
(12.3 - 13.7 ft ・ lb.)
23) GOVERNOR LEVER
Attach governor rod and rod spring between
governor lever and carburetor throttle lever, and
insert the governor lever to governor lever
shaft. Tighten locking bolt temporarily.
Tightening torque
6.9 - 8.8 N ・ m
(70 - 90 kgf ・ cm)
(5.1 - 6.5 ft ・ lb.)
Ignition coil air gap
0.3 - 0.5 mm
(0.012 - 0.020 in.)