MIDDLE
POSITION
HIGHEST
POSITION
LOW ANGLE
POSITION
TRANSPORT
Wheel Adjustment
The rear wheels can be set in three positions to provide the
optimal blade contact angle with the floor. The two Rear
Wheel Adjustment Plates can be adjusted by removing the
two Security Pins, setting the wheel at the desired height,
then reinserting the two pins through holes in the Adjustment
plates and the Frame of the Stripper.
For transport, flip the wheel assembly to the rear of the
Stripper Machine.
The positions are shown in the illustrations below.
Installing and Changing Blades
Blades are held in place between
the Upper and Lower Blade
Holder plates by two Hex Cap
Bolts. The Lower Blade Holder
Plate is threaded, so nuts are not
required. To change blades,
loosen the two hex cap bolts;
remove the blade, and install a
new blade. Note the Robert’s
blades are sharpened on both
sides, so the blade can be
reversed to get a sharp edge.
BEVEL DOWN FOR
WOOD SURFACE
BEVEL UP FOR
CONCRETE SURFACE
SECURITY PIN
For Wheel Height
Adjustment