R O B E R T S
-
G O R D O N
S E C T I O N
7 :
C O M P O N E N T I N S TA L L AT I O N
pg 19
Beam
Clamp
I-Beam
S-Hook
Anchor
Concrete Beam
Locknut
Washer
Screw Hook
3/8" (9.5 mm)
minimum
Washer
Wood Beam
12" (30 cm)
minimum
3/16" (5 mm)
or larger
Chain
Figure 16. Typical Suspension Details for Indoor Installation Only
Figure 17. Turbulator Baffle Assembly Detail
Attach a wire to this tab.
Turbulator adapter piece
"Twist Lock"
sections together
Turbulator 2.5 ft.
section piece
Pull turbulator into
tube using long wire
Lock tab in place
with vent adapter
To Burner
Last standard section of
heat exchanger tubing
TURBULATOR INSTALLATION
For ease of installation, the turbulator should be installed in the tube before hanging the system.
Use the following procedure (see Figure 17):
1. Assemble turbulator pieces by “twisting” matching ends
together.
2. Insert a long wire (11 ft. (3.3 m) minimum) down the
length of the tube. Attach the wire to the hole in the tab
on the adapter piece.
3. Using the wire, pull the assembled turbulator into the
tube from the opposite end. Pull the turbulator through
until just the tab comes out. Detach the wire.
4. Bend the tab around the tube. When installed, the vent
adapter will lock the tab in place.