Roberts Gorden BZC 100, Operation Manual, Page: 5 / 16

◆ ◆ SECTION 1: INTRODUCTION
1.1 WHAT IS A ROBERTS GORDON ® BZC
CONTROLLER?
The ROBERTS GORDON ® BZC 100 and BZC 300
are micro processor based controllers designed
for the most efficient control of CORAYVAC
® ,
BLACKHEAT ® and CARIBE ® heaters.
The ROBERTS GORDON ® BZC 300 controller is
capable of giving control outputs from 5 relays, 3
of which afford heating zone control capabilities.
The controller also features 6 inputs which are
used for signal condition monitoring.
The ROBERTS GORDON ® BZC 100 controller is
capable of giving control outputs from 3 relays, 1
of which affords heating zone control capabilities.
The controller also features 2 inputs which are
used for signal condition monitoring.
1.2 GENERAL REQUIREMENTS
The ROBERTS GORDON ® BZC series of con-
trollers are supplied pre-configured for their appli-
cation and only for use with ROBERTS GORDON
®
infrared heating equipment. Failure to comply with
the installation instructions and configuration will
invalidate the limited warranty set out on
Page 11,
Section 5.
Mount the ROBERTS GORDON ® BZC Controller
Quick Programming Guide next to the controller
for easy reference of programming steps.
See
Page 3, Section 2, Figure 2.
1.3 SAFETY
Your Safety is Important to Us! This sym-
bol is used throughout the manual to noti-
fy you of possible fire, electrical or burn
hazards. Please pay special attention
when reading and following the warnings
in these sections.
For optimum heater performance and safe heating
conditions, inspect and maintain heater(s) before
every heating season and as necessary. Also,
know and maintain heater clearances to com-
bustibles, see heater Installation, Operation and
Service manual for further details. If you require
additional manuals, contact your ROBERTS
GORDON
® independent distributor or Roberts-
Gordon at (716) 852-4400 or (800) 828-7450 in
the U.S., (905) 945-5403 in Canada or at www.rg-
inc.com.
1
SECTION
1:
INTRODUCTION
WARNING
Installation, Service and Annual Inspection of
controller must be done by an electrician qualified
in the installation of control systems for heating
equipment.
Installation, Service and Annual Inspection must be
done by a contractor qualified in the installation and
service of gas-fired heating equipment.
Read this manual carefully before installation,
operation, or service of this equipment.
Failure to follow these instructions can result in
death, injury or property damage.