Robe Stage Banner 10 AT Series, User Manual

Page: 15 / 21

14 15
Current temperature on the main board in the base of the
fixture.If temperature exceeds 87°C,the fixture will go to the "Power
down" mode.
Hi.tE.
---
Maximum fixture temperature
.
The function shows the max.temperature on the main board since
the StageBanner 10 AT has been fabricated.
HEAd
- The function shows the max.temperature of the head inside since
the StageBanner 10 AT has been fabricated.
rSEt
---
Maximum resetable temperature.
The function shows the maximum temperature on the main board
since the counter was last reset.In order to reset the counter to 0 you have
to hold [UP] and[DOWN ] and press the [ENTER].
DM.In. --- Readout of DMX values .Select this function to read DMX values (0-255) of each channel received
by the fixture.
PAn a coarse pan movement
F.PAn a fine pan movement
SPEd a pan speed
Func
pan functions
VErS.
---
Software version
.Select this function to read the software version of processors:
IC1.b.
--- Main processor on the main board in the fixture base
IC2.b.
--- Pan processor on the main board in the fixture base
IC3.b.
--- EEprom on the main board in the fixture base
8.4 Personality
Use this menu to to modify the StageBanner 10 AT operating behavior.
r.PAn
---
Pan reverse
.Select this function to invert the pan movement.
DiSP.
---
Display adjusting
.This function allows you to change the display settings.
turn
--- Select this function to turn the display by 180°.
d.On --- This function allows you to keep the display on or to turn off automatically 2 minutes
after last pressing any button on the control panel.
d.Int. --- Select this function to adjust the display intensity (20-min.,100-max.).
bL.Co. --- Blackout during movement correction .Select this function to enable the blackout during the
head movement correction (if the moving head lost its right pan/tilt position for a short moment).
FEEd --- Pan feedback .This function allows to return the mowing head to the required pan/tilt position after
changing the position by external force (e.g.by stroke).
Be careful, the Pan Feedback OFF is not the standard operation and the fixture can be demaged!
Note: If the feedback was switched off ,the pan/tilt-position is changed by an external force and the feedback
is switched on again,the fixture might not to be synchronized with the DMX signal.You have to make a reset in
order to synchronize the fixture with the DMX signal.
Mi.SE.
---
Microphone sensitivity
.Select this function to adjust the microphone sensitivity from 1(maximum) to
20(minimum).If the sensitivity is correctly adjusted,the upper segment of the first digit blinks in the bass beat.
Examples:
underexited right level overexited
(upper segment blinks via a bass rhythm)
Fan.S.
---
Fan speed operating modes
.By using this function you can choose 2 types of the fan speed op-