24
7.6 Tab "Service"
Adjust DMX Values
- The menu allows you to set all effects to desired positions before fine calibration of the
effects .
Calibrations
- This menu enables fine calibration of fixture effects and download default calibration values.
Calibrate Effects
- The menu allows the fine adjustment of effects.
Pan
- a pan position fine adjustment
Tilt
- a tilt position fine adjustment
Calibration of the effects via the control board
1. Disconnect DMX controller from the fixture and enter the "Calibrate Effects" menu.
2. Use the [up arrow] and [down arrow] to find "Pan" and touch it to enter the fine effect adjustment screen.
3. Set desired value and save it by touching the [confirm].
4. Repeat steps 2 and 3 for next item
5. After calibrating all effects, touch the [confirm] to save all adjusted values and reset the fixture.
Calibration protocol:
Effect
Pan-fine adjustment
channel 18
Tilt - fine adjustment
channel 19
Calibrate Pan/Tilt EMS
- This menu item allows calibration of the pan/tilt
electronic motion stabilizer.
Important: during this calibration any external force must not influence the fixture and the surface at which
the fixture stands (or truss if the fixture hangs) has to be without movement, shake, strokes etc.
Load Default Calibrations
- The item loads default (factory) calibration values.
Update software
- T
he menu item allows you to update software in the fixture.
The following items are required in order to update software:
- PC running Windows or Linux or macOS
- DSU file
- Flash cable RS232/DMX (P/N13050624) or Robe Universal Interface / Robe Universal interface WTX.
To update software in the fixture:
1. DSU file is available from Robe web site at WWW.robe.cz.
File with extension zip is intended for Windows (used and tested from XP to W10 on 32/64bit systems).
File with extension tbz is intended for Linux (used and tested on Debian and Ubuntu 32/64bit).
File with extension dmg is intended for macOS (used and tested on OSX up to Sierra) XQuartz required,
install it from https://www.xquartz.org/
Save the download file to a folder on your computer.
In case that you use windows, extract files in the zip file (e.g. DSU_RobinTarrantula_18051835.zip)
2. Disconnect the fixture from DMX controller.
3. If you use the flash cable RS232/DMX, connect a serial port of your computer with DMX input of the fixture
by means of the cable (probably you will need some USB to RS 232 converter if your computer has
USB ports only).
If you use the Robe Universal Interface, connect a USB port of your computer with the Robe Universal Interface
by means of the USB cable and DMX input of the fixture with the DMX output of the Robe Universal Interface
via a DMX cable.
Summary of Contents for Robin Tarrantula TW
Page 1: ...1 Version 1 3 ...
Page 35: ...35 12 Photometric diagrams without beam shaper ...
Page 40: ...37 ...
