Robe ROBIN iBeam 250, User Manual

Page: 34 / 43

34
13. Cleaning
Regular cleaning will not only ensure the maximum light output, but will also allow the fixture to function reliably
throughout its life.
The frequency of cleaning depends on the environment in which the fixture operates: damp, smoky or particu -
larly dirty environments can cause greater accumulation of dirt on the fixture housing.
The front glass cover of the head will require cleaning on a monthly basis.
A soft lint-free cloth moistened with any good glass cleaning fluid is recommended, under no circumstances
should alcohol or solvents be used!
DANGER !
Always disconnect the fixture from mains before starting any cleaning or maintenance
work.
Important! Never use alcohols (ethanol, methanol, isopropyl alcohol), acetone and
another aggressive solvents for cleaning the front lens array.
Note: potential foggy front lens array does not influence function of the fixture and does not subject to complaint
14. Maintenance
User can do replacement of the main fuse, another maintenance and service operations should be carried out
by trained technician only.
Regular inspections are recommended to ensure proper function and extended life.
Be sure all screws and fasteners are securely tightened at all times. Lose screws may fall out during normal
operation resulting in damage or injury as larger parts could fall.
Damaged rigging points or unsecured rigging could cause the fixture to fall and seriously injure persons.
Electric power supply cable must not show any damage.
Ff you need any spare parts, please order genuine parts from your local Robe distributor.
Replacing the fuse.
Before replacing the fuse, disconnect the fixture from the mains.
1. Using a screwdriver, unscrew (anti-clockwise) the fuse holder cap from the housing of the base.
2. Remove the blown fuse from the fuse holder.
3. Place a good fuse (only the same type and rating) into the fuse holder.
4. Screw the fuse holder cap back to the housing of the base.
Checking plastic parts of the fixture.
The plastic parts of the fixture should be checked for damages and beginning cracks at least every two months.
If hint of a crack is found on some plastic part, do not use the fixture until the damaged part will be replaced.
Cracks or another damages of the plastic parts can be caused by the fixture transportation or manipulation and
also ageing process may influence plastic materials.
This checking is necessary for both fixed installations and preparing fixtures for renting. Any free moving parts
inside of the fixture head, cracked plastic or any plastic part not sitting properly in place need to be immediately
replaced.
Fuse holder cap