7
4.3 Replacing the colour filters
DANGER!
Install the colour filters with the device switched off only.
Unplug from mains before!
Colour filters
1. Disconnect the fixture from mains and allow it to cool.
2. Remove the top plastic cover of the head by loosening the 4 quarter-turn fasteners on the cover.
3. Turn the colour wheel to the desired position.The dichroic filters are fixed on the colour wheel by the
magnets.
4. Release the dichroic filter from the colour wheel by inclining it from its position
to break the power of the magnet. Protect the glass filter with a piece of paper or clout.
5. Insert a new dichroic filter into the colour wheel.
6. Place the top cover back before applying power.
4.4 Installing top hats
The Robin 300 Plasma Wash can be fitted with various types of the top hats-see chapter the "Technical spe
-
cifications".If you wish to install a top hat (optional),follow the instructions:
Switch the device off before installing the top hat!
1.Loosen 4 lens holder quarter-turn screws and hook both securing springs to the plastic projections in the front
lens-holder.Tighten the 4 lens holder quarter-turn screws again.
2.Put desired top hat onto a front lens-holder and fasten it by two fastening screws.
3.Snap both springs to the slots in the top hat.
Centering hole
Dichroic filter
Magnet
Slot
Securing spring
Plastic projection
Securing spring
Top hat
Fastening screw
Fastening screw
Lens-holder
Summary of Contents for Robin 300 Plasma Wash
Page 1: ... Version1 5 ...
