10
8.Control board
The control panel situated on the top cover of the REDPower 1•7 allows DMX addressing,calling Built-in pro-
grams and setting the fixture behaviour
Control elements:
[ENTER] button- enters menu,confirms adjusted values and leaves menu.
, [UP] button and[DOWN] button- moves between menu items on the the same level, sets values.
In order to leave the menu without saving value,press [UP] and [DOWN ] at the same time.
After switching on the REDPower 1•7 ,the display shows the initial DMX address:
Use [UP],[DOWN] to browse through the menu. To select a function or submenu,press [ENTER].
8.1 Addressing the REDPower 1•72
The fixture can be operated in the two modes:
DMX mode
-fixture is controlled via DMX 512 by an external
DMX controller
Stand-alone mode
- fixture uses Built-in programs and is
able to control other fixtures in the master/slave chain.
See the chapter "Stand-alone mode" for detail description.
For DMX mode, it is important to define the starting DMX address from which the REDPower 1•72 will respond
to the DMX controller
Setting the DMX start channel for DMX operating:
1.
Connect REDPower 1•7 to the mains.
2.
Browse through the menu by pressing the [UP] and [DOWN] buttons until the display shows current addres
"001"
.Confirm by pressing [ENTER] button and
"001"
will start to flash frequently.
3.
Use the [UP] and [Down] buttons to select the desired address.
4.
Confirm by pressing [ENTER].
After having addressed REDPower 1•7
,
you may now start operating REDPower 1•7 via your DMX control-
ler.
8.2 Program running
By entering this menu a complete overview of all programs is offered,from which the program to be run can be
selected by pressing [ENTER].Selected program runs in a loop.The fixture includes 6 built-in programs (P.01-
P.6) and 3 free editable programs (E.P.1-E.P.3),each up to 30 steps.
If item "
AUt
" is On,the fixture in DMX mode will remember last running program and this program will run after
switching on the fixture.
Each program step has a fade time - the time during which effects go to the current step and a Standing time-
-the time,during which effects last in the current step.
Summary of Contents for REDpower 1-72
Page 1: ...version 1 1 ...
