Divine 60 UV
7
3.2 Mounting the fixture
The Divine 60 UV can be arranged in any position/orientation without altering its operation characteristics. The LED
module can be tilted to desired position by means of the tilt lock.
The Universal base adaptor of the fixture (8) is equipped with two pairs of rubber feet (6) for standing the fixture
on the floor and three pairs of openings (7) for installation of the mounting brackets Omega CL (9) which allow to
rig the fixture to the truss.
For overhead installation, the fixture must be always secured with a safety wire.
A structure (truss) intended for installation of the fixture (s) must safely hold weight of the fixture(s) placed on it.
The structure has to be certificated to the purpose.
The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
before taking into operation for the first time and after changes before taking into operation another time.
IMPORTANT! Overhead installation requires extensive experience including calculating working load limits,
installation material being used, and periodic safety inspection of all installation material and fixtures.
Fixtures may cause severe injuries when crashing down! If you have doubts concerning the safety of a possible
installation, do not install the fixtures and consult installation with an expert.
CAUTION!
Use 2 mounting brackets Omega CL and appropriate clamps to rig the fixture on the truss.
Make sure that the device is fixed properly!
Ensure that the structure (truss) to which you are attaching the fixtures is secure
.
The fixture must never be fixed swinging freely in the room.
For securing the fixture to the truss, install a safety wire which can hold at least 10 times the weight of the fixture.
Use only the safety wire with a snap hook with screw lock gate.
Truss installation
1.Bolt clamp to the bracket Omega CL (9) with M12 bolts and lock nuts through the hole in the bracket
Omega CL.
2.Fasten the two brackets Omega CL on the universal base adaptor (8) by means of the quick-lock fasteners (10)
and tighten them fully clockwise.
3. Fasten the safety cable (11) in the attachment point (5) and around the truss.
