9
STATUS_ID_DESCRIPTION
*
LAMP_STATE
*
*
LAMP_ON_MODE
1
*
*
DEVICE_HOURS
2
*
LAMP_HOURS
2
*
LAMP_STRIKES
2
*
1
...Another options for this command (only for Robe´s fixtures):
value PARAMETER_DATA=0x84 - lamp OFF by DMX value on DMX channel
value PARAMETER_DATA=0x88 - lamp OFF if DMX is not present
2
...Commands relative resetable values
11. Error and information messages
Occured errors during fixture operation are signaled by warning icon on the display:
Press [ESC] to see the current error messages. Description of error messages:
Overheated-Lamp Off
This message informs that the fixture head had been overheated and the lamp was switched off by head tem
-
perature sensor.
Overheated-Lamp Low
This message informs that the fixture head has been overheated and the lamp power is reduced.
Short Power Error
This message will appear if the fixture was shortly disconnect from the main.
Supply Frequency Error
This message will appear if the frequency of the main is not standard 50 or 60 Hz.This message can appear as
a result of the interference during the lamp starting (if the lamp or igniter is old) or as a result of the interference
by neighbouring devices.
In these cases the message does not affect the fixture operating!
Temper.Sensor Error
The message informs you that the communication betwen the head and the main board in the fixture base was
cut off (or the head temperature sensor is defective) and the lamp was automatically switched off.
Power down mode
This message will appear if the fixture is switched to the "Power down mode" (e.g. fixture head is
overheated).
The following error messages are separated into groups:
xxxx xxxx Error 1
(e.g.
Colour Wheel Error 1
)
xxxx xxxx Error 2
(e.g.Colour Wheel Error 2 )
There are some possible reasons of faults:
Message
Characteristic fault
xxxx xxxx Error 1
Magnetic sensor is permanently On (e.g. leading wire is short-
circulated,defective stepping motor, defective control circuit on the
PCB)
xxxx xxxx Error 1/xxxx xxxx Error 2
Magnetic sensor is permanently Off(e.g.leading wire is disconnected,
defective magnetic sensor,missing magnet),defective stepping motor
Effect Wheel Error 1 (Effect Wheel Error 2 )
The messages will appear after the reset of the effect wheel if this wheel is not located in the default position.
Effect Index. Error 1 (Effect Index. Error 2 )
The messages will appear after the reset of the effect wheel if the beam shaper wheel ls are not located in the
default position.
Optical Zoom Error 1 (Optical Zoom Error 2 )
The messsages will appear after the reset of the zoom module if the zoom lens is not located in the default
position.
Summary of Contents for Color Wash 750 AT Tungsten
Page 1: ... Version 2 0 ...
Page 35: ...35 ...
