4.7 DMX-512 connection
The fixture is equipped with both 3-pin and 5-pin XLR sockets for DMX input and output.The sockets are wired
in parallel.
Only use a shielded twisted-pair cable designed for RS-485 and 3-pin or 5-pin XLR-plugs and connectors in
order to connect the controller with the fixture or one fixture with another.
DMX - output
DMX-input
XLR mounting-sockets (rear view):
XLR mounting-plugs (rear view):
If you are using the standard DMX controllers, you can connect the DMX output of the controller directly with
the DMX input of the first fixture in the DMX chain. If you wish to connect DMX controllers with other XLR-out
-
puts, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.Up to 32 fixtures can may
be connected on a serial link.
Caution:
At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
Ω
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
1
- Shield
2
- Signal (-)
3
- Signal (+)
4
- Not connected
5
- Not connected
1
- Shield
2
- Signal (-)
3
- Signal (+)
4
- Not connected
5
- Not connected
Summary of Contents for Color Wash 750 AT Tungsten
Page 1: ... Version 2 0 ...
Page 35: ...35 ...
