Robe Color Wash 700E AT, User Manual

Page: 26 / 37

6
Microphone Sensitivity --- Select this function to adjust the microphone sensitivity from 1(maximum) to 20(mini -
mum).If the sensitivity is correctly adjusted,the mark will appear (blinking in the bass beat.)
Fan Modes
--- By using this function you can choose types of the fan speed operating modes.
Auto Cooling
--- The fans automatically raise their speed in order to control inside tempe-
ra-
ture of the lighting, if the temperature inside increases about certain level (the low fan speed
reduces the cooling of the lighting). This cycle can repeat several times until the temperature
inside is on a suitable level.
High Cooling --- The cooling fans work on max. speed (max. cooling).This mode we re-
commend for high ambient temperature (30 °C and more).
Pan/Tilt mode --- Use this menu to set the character of the pan/tilt movement.
Time mode --- Pan and tilt will move with different speeds and they will come at the same
time to end point (pan and tilt sets its optimal speed).
Speed Mode --- Pan and tilt will move with the same speed as adjusted by the channel 5
(Pan/Tilt speed).E.g. pan will come to the end point and wait for tilt,which has longer track.
Active Blackout while:
--- Use this function if you wish to close the light output during effect changes.
Pan/Tilt Moving ---
This function closes the light output during changing pan/tilt positions.
Colour Wheel Moving ---
This function closes the light output during changing colours.
Dimmer Curve
- Select desired dimmer running.
Curve Curve
Spot 700 CMY Simulation
--- If the menu item is on, the running of CMY+CTC flags simulate their
behaviour in the ColorSpot 700E AT.
IR Sensor
--- Select this function to switch on/off infra-red remote control
.
Init Effect Positions --- Select this function to set all effects to the desired positions.After switching the fixture
on (if DMX is not connected),all effects will move to these init positions.
Temperature Unit --- Select this menu in order to display fixture temperatures in °C or °F.
Default Settings --- Select this option to reset all fixture personalities to the default values.
8.4 Lamp On/Off
Use this option in order to switch on/off the lamp.It is also important to note, that the lamp is cold restrike type,
that means, that it has to be cold before striking.
8.5 Test sequences
Use this menu to to run a special demo-test sequences without an external controller, which will show you
some possibilities of using ColorWash 700E AT.
Mode 1 --- This mode is suitable for projections on the wall, ceiling or ground without any
head movement.
Mode 2
--- This mode uses all ColorWash 700E AT functions including pan/tilt movement
and therefore is good for a complete introduction of the fixture.
8.6 Manual mode
Preset Effects --- Select this menu to call up presetted positions of channel effects.
Manual Effect control --- Select this menu to control channels by control elements on the control
board.