35
10. Error and information messages
Occured errors during fixture operation are signaled by warning icon on the display:
Press [ESC] to see the current error messages. Description of error messages:
Active Lamp Timer
This message appears:
1. If you try to switch on the lamp within 5 minutes after having switched it off (the lamp is too hot). The message
will appear on the display if the lamp doesn't ignite within 28 seconds. The COLORSPOT 1200 AT will store this
information and automatically ignite the lamp when the 5 minutes period has expired.
2.If the lamp was switched off by the thermostat (head is overheated) and the fixture ignites the lamp again.
Caution: The message is disabled if the lamp light sensor (function "Lamp Sensor"in menu Personality) is switched
Off.
Lamp Error
The ignition of the lamp is seven times unsuccessful (the "
Active Lamp Timer" message appeared six times
before), and the display shows "
Lamp Error", meaning that the lamp could be damaged or even missed or there
could be a failure on the ignitor or ballast.
Please place or replace the lamp and contact your dealer if the situation was not caused by the lamp.
Caution: The message is disabled if the lamp light sensor (function "Lamp Sensor" in menu Personality) is
switched off.
Lamp Sensor Error
This message informs the lamp light sensor is failed.
Caution: The message is disabled if the lamp sensor (function Lamp Sensor in menu Personality) is switched Off.
Fan 1: speed is out of range
This messsage informs you that the speed of the fan is out of its speed range.The same message exists for fans
Fan2...Fan11(e.g.Fan 11:speed is out of range).
Fan 1 does not run
This messsage informs you that the fan doesn't work.The same message exists for fans Fan 2...Fan11(e.g. Fan
11 does not run.
Short Power Error
This message will appear if the fixture was shortly disconnect from the main.
Supply Frequency Error
This message will appear if the frequency of the main is not standard 50 or 60 Hz.
Master - DMX Collision
The message informs you that the fixture was addressed as a master and DMX signal is connected to its
input.Disconnect the DMX controller from the fixture input and address the fixture as the master again.
Active Lamp Timer
This message will appear if you switch off and on the lamp within 5 minutes.The fixture will automatically ignite
the lamp when the 5 minutes period expire.
The following error messages are separated into 2 groups:
xxxx xxxx Error 1 (e.g.
Colour Wheel Error 1 ,Gobo 2 Index Error 1)
xxxx xxxx Error 2 (e.g.Colour Wheel Error 2 ,Gobo 2 Index Error 2)
There are some possible reasons of faults:
Message
Characteristic fault
xxxx xxxx Error 1
Magnetic sensor is permanently On (e.g. leading wire is short-
circulated,defective stepping motor, defective control circuit on the PCB)
xxxx xxxx Error 1/xxxx xxxx Error 2 Magnetic sensor is permanently Off(e.g.leading wire is disconnected,
(together)
defective magnetic sensor,missing magnet),defective stepping motor
Summary of Contents for Color Spot 1200 AT
Page 1: ...1 ...
Page 40: ...40 Beam path Lamp MSR 1200 SA ...
Page 41: ...41 ...
Page 43: ...43 ...
