Robe clubspot 500 CT, User Manual

Page: 8 / 26

8 9
4.5 Connection to the mains
Verify the power supply settings before applying power!
If you wish to change the power supply settings, see the chapter below.
Connect the fixture to the mains with the enclosed power plug. If you need to install other power plug on the power cable,
follow the identification table below.
The earth has to be connected!
Do not connect the fixture to a dimmer system!
The occupation of the connection-cables is as follows:
Cable (EU) Cable (US) Pin International
Brown Black Live L
Liht blue White Neutral N
Yellow/
Green
Green Earth
4.6 Changing the power supply settings
Both the transformer and the ballast must be connected correctly for the local AC voltage and frequency.
The wrong settings can cause poor performance or demage of the moving head. The factory settings are printed next to
the power switch.
If you want to change the power supply settings, follow the instructions:
1. Disconnect the fixture from AC power.
2. Remove the top base covers by unscrewing 9 screws on each cover.
3. Move the wire (1) on the transformer connection block to the position according to the desired voltage.
4. Move the wires (2) and (3) on the ballast connection block to the position according to the desired frequency (voltage).
5. Close the base before applying AC power.
Examples:
Power supply settings: 230V / 50Hz