Robe ANOLIS Subdrive 4, User Manual

Page: 10 / 20

10
"tEM.U" --- Temperature Unit . Use this menu item in order to display the ArcSource Submersible II temper-
ature in desired units: °C or °F.
"LoAd" --- Load . Use this menu to set a desired power to the connected ArcSource Submersible IIs. You can
set different power to each LED output ( LEd1, LEd2,LEd3, LEd4 ).
"Min." - Minimum mode (35W).
"MEd." - Medium mode (70W).
"MAX." - Maximum mode (100W).
"In.Po." --- Init effect positions . Use this menu to set effects to desired positions to which they will move after
switching the fixture on without receiving DMX signal.
"dF.SE" --- Default Setting .The menu item sets certain fixture parameters to the default (factory) values:
"M. F.ti." = 0.1
"rGb.C." = On
"tEM.U" = °C
"LoAd" =MEd
5.4 Manual mode ("Man.C.")
Use this menu for control the fixture without connected DMX console.
To control fixture channels.
1. Use the UP/DOWN buttons to find “ Man.C“ menu.
2. Press the ENTER button.
3. Use the UP/DOWN buttons to select desired effect (channel).
List of control channels:
“rEdA.” - all red LEDs saturation
“GrE,A.“ - all green LEDs saturation
“bLu.A.“ - all blue LEDs saturation
“Vhi.A.“ - all white LEDs saturation
"AMb.A" - all amber LEDs saturation
“CtO“ - a colour temperature correction
“V.C.Vh“ - a virtual colour wheel
“Stro“- a strobe, shutter
“dim“- a dimmer
“din.F” a fine dimmer
4.Press the ENTER button and use the UP/DOWN buttons to set value , press the ENTER button to confirm it.
5.5 Test sequences ("tESt")
Use this menu to run test sequences without an external controller, which will show you some possibilities of
using the ArcSource Submersible II.
5.6 Stand-alone setting ("St.AL")
The fixtures on a data link are not connected to the controller but can execute pre-set programs which can be
different for every fixture.
"Auto" --- Automatic playback . This function allows you to select the program which will be played after
switching the fixture on. Selected program will be played continuously in a loop.
1. Use the UP/DOWN buttons to find “ St.AL" menu.
2. Press the ENTER button.
3. Use the UP/DOWN buttons to select item “Auto“ item.
4. Press the ENTER button.
5. Use the UP/DOWN buttons to select desired program (tESt, PrG.1, PrG2, PrG3). Option "OFF" disables
the function.
6. Press the ENTER button to confirm the choice.
"PLAy" --- Playing program . Use the menu to run desired program.
1. Use the UP/DOWN buttons to find “PLAy“ menu.
2. Press the ENTER button.
3. Use the UP/DOWN buttons to select desired program (tESt, PrG.1, PrG2, PrG3).
4. Press the ENTER button. The selected program runs in a loop.