programming
connection
connection for external
rechargeable battery
Seite
5
Use the programming card only within the limits of the technical specifications, otherwise the
card could be destroyed.
missions that do not comply with the requirements of this manual can cause problems in
operation, destroy the programming card and cause injuries. There are considerable dangers,
damage to property and personal injury can occur.
Protect the programming card from vibrations, dust, moisture and mechanical stress!
Do not expose them to extreme heat or cold!
Check the device at regular intervals for damage!
Technical specifications
92 x 52 x 6 mm
26 g
measurements
:
weight
:
Control Panel
1.
use the "up / down" button to select the pro-
programming parameters. Use the "left / right"
button in order to switch on the display during
the activated parameter to set the desired value.
2.
brake adjustment: When "Brake" is engaged-
the engine stops immediately when the
accelerator is switched off.lever is moved
to the lowest position.
3.
Undervoltage protection: If "soft-cut" off
is selected, the controller gradually reduces the
Output power. When "Cut-Off" is selected,
switches off the controller immediately
.
4.
Fourth cut-off voltage: Please read the operating
instructions.The controller's operating instructions
to obtain precise information for this parameter.
5.
Music / LiPo cells: The four LEDs have
undifferent meanings, depending on whether
the the regulator with normal voltage (2S - 6S),
or as a HV controller with more than 6S.
•
Regulators with normal operating voltage
such as the ROCONTROL 60 A, or the
ROCONTROL 60 A. The four LEDs
represent 16 possible states, which can
also be used as 16 music rhythms.
Can be given back again. The controller
outputs this melody at the time of the
(see Table 1).
•
For controllers with HV operating voltage, as the ROCONTROL PRO 130 A, HV OPTO,
the four LEDs indicate the number of cells of the connected LiPo batteries (see Table 2).
ROCONTROL programming card
Instruction manual
