ENGLISH
6
Instructions and User Manual
Summary: The SI-2EE brushless electronic control kit is a high-performance, multi-function vehicle-ship
model electronic control system. Due to its built-in receiver and electronic governor functions, it is a highly
integrated and complex function. For the products, the user must carefully check the instructions during
use to avoid damage caused by wiring and other errors.
Install the receiver anenna in the tube as shown.
Do not bend the end of antenna over the antenna
tube and place the cap over it or damage may
result. The antenna does not have to be outside of
the tube to operate properly.
Keep the end of the antenna above the boat´s
waterline to get the best transmitter reception.
Apply clear tape, if desired.
Notice:
Do not cut or kink the receiver antenna or dama-
ge may result.
1.
Loosen the 4 screws located at each corner
of the canopy.
2.
Remove the canopy from the hull starting
with the 2 rear screws. Ensure that the 4
screws have disengaged from their bases
before lifting the canopy carefully. To secure
the battery, use either the included self
adhesive foam pad or hook and loop tape.
We recommend hook and loop tape when
running your boat in rough water.
3.
Install the battery in the battery tray using
the hook and look straps.
4.
Connect the battery pack to the EC3™ con-
nector on the ESC.
IMPORTANT:
Perform a control check at the
beginning of each boating session, after repair or
after installing new batteries.
1.
Power ON the transmitter and the boat.
Do
not install the boat canopy.
2.
Place the boat securely on the boat stand.
3.
Test the steering: Turn the transmitter steering
wheel to the left and to the right to check for
proper control movement of the steering noz-
zle in response to your transmitter input.
4.
Test the throttle: Apply minimal throttle and
check that the motor and flywheel are rotating
counterclockwise.
5.
If everything appears to be operating correct-
ly, prepare to operate the boat in the water.
Remote control failure processing
Fault phenomenon
possible reason
Solution
Theindicator does not
light after power-on.
The battery is not installed correct-
ly and the battery is low
Reinstall the battery or replace the battery
ESC fault handling
Fault phenomenon
possible reason
Solution
The indicator does not
light after power-on.
No working power supply;
the ESC switch is damaged
Check if the battery has power; check if the
power line is connected properly;
replace the switch
After the power is turned
on, the indicator lights
up for 1 second and then
turns off.
The remote control is not turned
on; the remote control is not on
the frequency
Turn on the remote control;
re-run the frequency
The indicator blinks once
every 1 second after
power-on.
Low battery voltage
Replacement battery
The vehicle automatically
moves after power-on
TRIM setting problem of remote
control TH
Adjust the TRIM of the remote control TH
so that the vehicle does not move when
TH is at the neutral point
The remote control does
the forward operation, but
the car goes backwards.
N/R setting problem of remote
control TH
Toggle the N/R of the remote control TH
to make the direction of motion of the
vehicle consistent with the direction of
throttle operation
The car can‘t reach full
speed
D/R setting problem of remote
control TH; low battery, low
voltage protection
Adjust the D/R of the remote control
TH clockwise to increase the D/R value;
replace the battery
The car can‘t move forward
and back, the indicator light
is long
Low battery voltage, low voltage
protection; disconnection between
ESC and motor; motor damage
Replace the battery; check the connection
between the motor and the ESC;
replace the motor
When the motor starts up,
it accelerates rapidly, and
the motor has stuck or
paused.
The battery has insufficient
discharge capacity; the motor
speed is too high, the gear ratio
is too aggressive; the car
transmission system has problems.
Replace the battery with high discharge
capacity; replace the motor or increase the
reduction ratio; check whether the frame
drive system is smooth
CO N T R O L C H E C K
B AT T E R Y PA C K I N S TA L L AT I O N
A N T E N N A T U B E I N S TA L L AT I O N
