Page: 6
SAFETY
GENERAL SAFETY
This machine contains no user-serviceable parts. Roband Australia, one of our
agents, or a similarly qualified person(s) should carry out any and all repairs. Any
repair person(s) should be instructed to read the Safety warnings within this manual
before commencing work on these units.
Steel cutting processes such as those used in the construction of this
machine result in sharp edges. Whilst any such edges are removed to the
best of our ability it is always wise to take care when contacting any edge.
Particular care should be taken when panels are removed (eg during servicing) as
this may expose sharp edges.
Do not remove any cover panels that may be on the machine.
This unit can get very hot, ensure everyone is aware that the machine is operating
and take care to avoid contact with hot surfaces. Hot surfaces should be left well
ventilated with an air gap of at least 100mm, though common sense should be used
if the machine is near heat-sensitive materials.
National Standards exist outlining the positioning, spacing and ventilation
requirements when installing new appliances. These Standards should be
consulted and new equipment should be installed accordingly. In any situation
where specifications allow a distance of less than 100mm we would still
recommend that a well-ventilated air gap of not less than 100mm be maintained. If
the machine is near particularly heat-sensitive materials common sense should be
employed in determining sufficient distancing.
Always ensure the power cable is not in contact with hot parts of the
machine when in use. Ensure that any damaged power cord is replaced
before further use.
Do not clean this unit with the aid of a Spray Applicator or Water Jet.
These units are not suitable for cleaning in a dishwasher and no parts of these
machines (except the grease box) should ever be submerged in water.
Keep out of reach of children or the inept.
IMPORTANT SAFETY NOTE FOR MODEL GMX810G:
If at any time one of the glass elements should break DO NOT USE THE
MACHINE. Turn the unit off AT THE WALL, being careful not to touch any part of
the machine, and remove the plug. Do not allow the unit to be used again until the
broken element has been replaced.
