- Open box, tilt onto open side, slide box up
- Undo 4 cover straps
- Set extrusion rails aside
- Undo 2 side straps
- Open tent, remove ladder, cover, boot bags, gear
hammocks, and hardware bag, leave window poles,
close tent
- Flip to side with 4 holes
- Cut off plastic cover
- Align extrusion rails
- Slide nuts into rails
- Locate holes on opposite side, push bolts through
tape, tighten
- Flip tent
- Cut off plastic cover, remove tape
- Align brackets
- Locate holes on opposite side, push bolts through
tape, don’t tighten
- Align ladder, feed bolts through, tighten
- Tighten brackets
- Install boot bags and gear hammock
- Secure ladder strap
- Install cover
- Lift onto vehicle
- Drop botls through slides and slide into rails
- Sandwich rack with plate and tighten
- Install extrusion end caps
- Undo 4 straps
- Flip back cover, slide out of frame
- Undo side straps
- Undo ladder strap
- Extend ladder, use to lever open
- Pull out ladder awning pole, flip out brackets,
insert, velcro
- Grab bag of poles, insert into frame, bend and
insert in awning
- Roll up window covers
- Lift ladder, zip on annex, zip on floor
- When closing, use bungees
- Remove cover
- Insert annex cord into frame
- Fold up ladder
- Zip annex on
- Layout and zip on floor
- Fold ladder back down
VEHICLE INSTALL
1) Lift the tent onto you rack and get it roughly centered.
2) Grab the eight sliding brackets. If the bolts are not installed, insert them
through the hole in the bracket so that the head sits flush inside the channel.
3) Slide 2 brackets into each corner of the mounting rails ensuring that they are
in the thin channel along the bottom of the rail.
4) The goal is the sandwich the bars of your roof rack, so lift each corner and
slide 1 of the brackets to the inside of the bar you will sandwich.
5) Now is a good time to double-check the position and get things nice and
centered.
6) Take the sandwich plates, slide them onto the bottom of the bolts, and secure
with the nylock nuts.
Sorry there are no pictures... :(
6
