- 1 -
Boss Shadow sun blockers easily mount into the awning tube groove without tools.
DIRECTION FOR USE:
1.
Open and set the awning according to the manufacturer's instructions.
2.
Unfold the sun blocker. It is easier to install if there are two persons.
3.
Insert the cord into the awning tube utility groove and start sliding the sun blocker towards
the other end. Ensure there are no sharp edges on the awning tube before you insert the sun
blocker. If the sun blocker does not slide easily use
MAGIC BOSS
TM
LUBRICANT &
PROTECTOR
, a teflon based product, and spray it into the awning tube groove.
4.
Always keep the sun blocker aligned with the awning tube groove while sliding it in.
5.
Slide it all the way across to the other end or until the sun blocker is centered on the awning
tube.
6.
Fit the bottom portion to the top portion using the zipper.
7.
Use the stakes & bungee cords provided to anchor the bottom of the sun blocker through the
grommets into the ground.
8.
Use the bungee ball fasteners provided to secure the top of the sun blocker to the awning
tube.
CAUTION:
•
In windy conditions it is recommended that the sun blocker be removed and the awning rolled
up to prevent damages.
•
Do not roll up the awning with the sun blocker installed.
FABRIC CARE:
1.
Do not use any caustic, granulated or abrasive type cleaners.
2.
The best way to keep the fabric looking good and to delay the need for deep or vigorous
cleanings is to hose the fabric off on a monthly basis with clear water. This practice will help
prevent dirt from becoming deeply imbedded in the fabric.
3.
However, a thorough cleaning will be needed every year. The fabric can be cleaned while still
installed on the awning tube. Use a soft brush and warm water with
MAGIC-BOSS™
CITRUS AWNING CLEANER
,
a natural and eco-friendly product specially formulated to
remove built up dirt, tree sap and tough stains. Air-dry only. Never apply heat to the fabric.
Always allow the fabric to dry thoroughly before folding and storing
.
