26
Step 3:
Each output module (OP) or blanking plate (BP) is secured to the pivoted lid through a couple of screws. A power supply,
however configured, does have eight pairs of screws visible on the upper surface of the lid. When re-configuring a power
supply only remove the screws that hold an OP while leaving tightened BP’s ones.
Step 4:
Once all the screws that hold the OPs has been removed, the next step is opening the lid by rotating it around the two pins
that bind it to the chassis. Ensure that all output modules are detached from the lid, before doing so.
Once the cover has been rotated at the most comfortable angle, it is possible to remove any BPs as required by the new
configuration needed.
DISTRIBUTED BY TEXIM EUROPE