2018+ JL WRANGLER FULL
-
WIDTH FRONT
Page ( 6 of 8 )
www.
ROADARMOR
.com
INSTALL INSTRUCTIONS
16
Install hardware onto the 1/2” bolt tabs. Place bracket flush with bumper on one side and tighten
1/2” hardware.
(Make sure the top bolt tabs are in there up
-
most position and the bottom bolt
tabs are in the lowest position.)
17
Measure from the bottom of the secured bracket to a fixed point of the bumper. Measure the
other bolt on bracket in the same location and secure using the 1/2” hardware.
15
Now place the brackets into the bumper. This is achieved by placing the tow took though the
hole of the bumper and aligning the top bolt first. Then, push the bracket onto the bottom bolts.
(When putting the bracket onto the bottom bolts you may have to give it a slight push.)
15
